how do i make a follower logic work properly with a tag...?

EternalDarknessz 30 يناير، 2019 02:35

when using a follower and and tag logic the follower does goto the tag but unless LBP2 where it will go to the tag then keep dead still or follower moves smooth and perfect, here it goes to the tag then dances around even when the tag is dead still the follower wont keep still, is this a bug or something? what i wanna do is if the follower is following something that moves with a tag on it that it wil just follow smooth.

• 

  Arcas-X

  • 30 يناير، 2019 05:27

  Sounds like the follower minimum distance is too low. Set it to 1 or something similar. Alternatively you can make the follower non collidable.

  0

  الإبلاغ عن هذا المنشور
• 

  raz0rbackzwei

  • 30 يناير، 2019 10:47

  Also increase the damping. This will stop the following object from shaking

  0

  الإبلاغ عن هذا المنشور
• 

  Mm Dev 6 - Cat/Tom C

  • 30 يناير، 2019 11:06

  HI there!
  
  Yup as comments have mentioned on the Damping, you'll want to play around with a higher damping value, 100% will mean literally no shaking around, or slightly lower than 100% if you want it to have a little bit of ping to it, but not constant shaking.
  
  Thanks,
  Cat

  0

  الإبلاغ عن هذا المنشور

الرجاء تسجيل الدخول لترك تعليق.