Why does the count logic have a time limit regarding how fast it can be added another +1?

Stampy83 30 ديسمبر، 2018 00:24

Basically i tested this on the Ame timeline, i added to sources to contribute to the count at the same time, but only one +1 was added. The second source was ignored. I then moved the 2nd source for a tiny bit on a time line, again it was ignored. Only when I moved it apart like 1 second or so, it was registered as an extra count. I don't get the logic behind this.

• 

  Aecert

  • 30 ديسمبر، 2018 04:56

  Try hooking the plus count up to a not gate that is wired into itself.

  0

  الإبلاغ عن هذا المنشور
• 

  jon-blue-eyes

  • 31 ديسمبر، 2018 03:38

  I think it’s because the add input is triggered by pulse only. So even if you wire in an always on input value, it’s only going to trigger the update when a full pulse happens.
  
  The Not trick should do it as that will cause the input to rapidly pulse between on/off every two frames!

  0

  الإبلاغ عن هذا المنشور

الرجاء تسجيل الدخول لترك تعليق.