Wireblend function - Overwrite, Blend, Modulate ???

CURTROCK 22 اغسطس، 2019 02:06

Can somebody explain these 3 types to me? I don't understand the definitions that Mm give you when you hover over this function. I'm sending an audio signal into a light to modulate the brightness, and I really don't want any type of "processing" to be introduced on the wire hookup. I'm not sure which of the 3 choices given I should choose. Thank you, in advance.

• 

  TAPgiles

  • 22 اغسطس، 2019 06:13

  My docs discuss this in detail: https://docs.google.com/document/d/1gvFqQl84-kEIO0u3PRTXmXMQDEcnV8kCm80bLNur_7M/edit#heading=h.n34zrokuiu27
  
  The basics: For a single wire coming in, "overwrite" or "blend" will set the slider's value. Modulate will multiply the slider's base value by the number coming in through the wire.
  
  So you might want to use "overwrite" here. Though the brightness of a light (or whatever) will normally accept a value from 0 - 1. So if the audio envelope goes higher than 1, it won't look right; the brightness will stick to 100% for a while instead.
  
  There are ways to fix that (involving a signal manipulator) I can get into if that problem comes up.

  0

  الإبلاغ عن هذا المنشور
• 

  Captain_Teamo

  • 22 فبراير، 2020 13:41

  Blend mode was made no sense, what happen actually?

  0

  الإبلاغ عن هذا المنشور

الرجاء تسجيل الدخول لترك تعليق.