Is there a way to change a part of a sculpture to varying looseness after it is placed?

Koltonaugust 27 يناير، 2019 23:09

I realized about halfway through a sculpture that I meant to make the base varying looseness, but somehow it got unchecked. Can I change this after the fact?

• 

  squarecape

  • 28 يناير، 2019 14:48

  The way I did it was with the cut out tool. It cuts out a piece of the sculpture, then u can change the looseness of that using style mode. Alternatively, u could just delete a piece of the sculpture and make an identical one that fits in that piece.
  
  For example, when I had to do this, I had a large rectangle sculpture, but I wanted a smaller circle sculpture within that rectangle sculpture to have a different looseness and fleck type and such, so I used the stamp tool and set it to delete, and deleted a small portion on the inside of the rectangle. I then created a circle sculpture and fit it inside that hole in the rectangle.
  The cutout tool is much faster but i couldn’t find out how to change the shape of the cutout, so it was always a square cutout

  0

  الإبلاغ عن هذا المنشور
• 

  Supposer

  • 29 يناير، 2019 08:32

  I'm not sure this is possible.
  
  If you're stuck, you can use the looseness tool to manually vary the looseness (eg. sharpen up the edges. https://youtu.be/0g0NVwVZGxE?t=5071

  0

  الإبلاغ عن هذا المنشور
• 

  Koltonaugust

  • 1 فبراير، 2019 01:22

  Thanks! I ended up just dealing with it as it wasn't noticeable in the grand scheme of things.

  0

  الإبلاغ عن هذا المنشور

الرجاء تسجيل الدخول لترك تعليق.