How do I connect the buttons of the controller to things?

phyfutima 3 يناير، 2019 19:18

Especially animation. If I animate something with keyframes and/or timelines, how do I make it so that pressing the trigger or any other button will trigger the animation?

• 

  mmdev1 - John & Luci

  • 3 يناير، 2019 19:44

  Hi,
  
  Use the control sensor gadget, it has all the outputs when you open it's tweak menu
  
  You may also want to set it to remote control, so it works all the time.
  
  John

  0

  الإبلاغ عن هذا المنشور
• 

  phyfutima

  • 3 يناير، 2019 20:16

  Thanks! Okay, so I've got R2 wired into a keyframe, but when I move the R2 slider to the right, it just goes back to 0%, I can't change the R2 percentage - is that a bug, or am I doing something wrong?

  0

  الإبلاغ عن هذا المنشور
• 

  Magus0Mind00

  • 3 يناير، 2019 21:31

  L2 and R2 are the only controller buttons that output a range from 0-1. All other buttons are boolean 1 or 0. Try wiring to a different button or wire R2 to a calculator that checks if the value is greater than 0, before the signal goes to your animation.

  0

  الإبلاغ عن هذا المنشور
• 

  Supposer

  • 5 يناير، 2019 11:26

  '@Phy: What do you mean by "move the R2 slider to the right"?

  0

  الإبلاغ عن هذا المنشور
• 

  phyfutima

  • 7 يناير، 2019 19:20

  '@Supposer: When I'm in the Controller Sensor tweak menu, at the top of the first page are L2 and R2 sliders that default to 0%. I can slide them to the right up to 100%, but when I let go they just go back to 0%.

  0

  الإبلاغ عن هذا المنشور

الرجاء تسجيل الدخول لترك تعليق.