Mr_Prince_Sanji3

  • Gesamtaktivitäten 8
  • Letzte Aktivität
  • Mitglied seit
  • Folge ich 0 Benutzer
  • Gefolgt von 0 Benutzer
  • Stimmen 0
  • Abonnements 2

  • Mr_Prince_Sanji3 hat einen Kommentar hinterlassen

    1. Community
    2. Archive
    3. How do I add multiple numbers?

    '@GBO-Possum Thanks! I was trying to avoid using a ton of calculators because I thought it would be messy, but your microchip was super organized! Worked perfectly too :)I'm making a dice calculato...

  • Mr_Prince_Sanji3 hat einen Post erstellt

    How do I add multiple numbers?

    1. Community
    2. Archive

    Can you use the calculator gadget to add more than 2 numbers together? For example, I want to add up to 10 different numbers together, without using a ton of separate calculator gadgets.

    • Mr_Prince_Sanji3
    • 3 Follower
    • 3 Kommentare
    • 0 Stimmen

  • Mr_Prince_Sanji3 hat einen Post erstellt

    How do you make a timer output a constant signal?

    1. Community
    2. Archive

    I was trying to power something on after a set amount of time, but the timer only ouputed a pulse. I tried using a signal manipulator and switch, but couldn't seem to figure it out. Any help would ...

    • Mr_Prince_Sanji3
    • 2 Follower
    • 4 Kommentare
    • 0 Stimmen

  • Mr_Prince_Sanji3 hat einen Kommentar hinterlassen

    1. Community
    2. Archive
    3. How do I put an object in a puppets hand?

    Ah ok, I'll give that a try!

  • Mr_Prince_Sanji3 hat einen Post erstellt

    How do I put an object in a puppets hand?

    1. Community
    2. Archive

    I'm trying to stick a candy cane in Santa's hand, but everytime I enter play mode, it falls to the ground. Both the hand and candy cane are collidable, movable and grouped together. What am I missing?

    • Mr_Prince_Sanji3
    • 3 Follower
    • 4 Kommentare
    • 0 Stimmen

  • Mr_Prince_Sanji3 hat einen Post erstellt

    How do you make the move controllers steadier?

    1. Community
    2. Archive

    I'm not sure if it was my setup, but I was having trouble making precise cuts when I was sculpting. Anyone having these issues?

    • Mr_Prince_Sanji3
    • 2 Follower
    • 2 Kommentare
    • 0 Stimmen