Cupra-AL
- Total activity 26
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 9
-
It's sorted now in this thread: https://feedback.indreams.me/forums/917434-dreams-how-do-i/suggestions/36349435-advanced-rotator-can-t-get-the-ball-to-rollA couple of tweaks to other settings was r...
-
OK, so I'm still stuck on this. I'll start from scratch again but I don't know quite what I am doing wrong. Thanks for all the advice though.One thing to clarify, does the X go to the X and the Y g...
-
Luci,I have tried for the past two hours to try and get the ball rolling and it's not budging :o)Is it correct that I should connect the X and Y outputs of the splitter to the X axis speed and Z ax...