GribbleGrunger
- Total activity 68
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 25
-
So you have to do each one separately? You can't sculpt one and clone it?
-
I forgot to mention, turn the imp sensitivity down to 1
-
I'm still not brilliant with it but i'm improving. Just stick at it.
-
I haven't done any accurate drawings by hand but I do know if you use the painting tool with snap on, it snaps to a flat surface of a sculpt. This is going to be a pain but how about making a bend ...
-
As I recall there's a 'map' you create of connected levels but I haven't seen it in the beta. Perhaps it's one of the things they've left out. When MM demonstrated it, they took a few levels, place...
-
Use the tool that allows you to bend it (can't remember the name), then cut it in half with a large square.
-
Thanks, John.
-
Oh, that's good to know, Pookachoo. I'll bare that in mind!
-
To give you a real world example of why you would want to do this: Imagine you've created a tree and then cloned that tree to make a forest. If you've live cloned it, if you decide to improve that ...
-
Klaw, I was getting confused because when I went back into sculpt mode, after live cloning, it appeared to only change two when I was cutting. It isn't until you pull back out that the others also ...