sleeperwolf

  • Total activity 4
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 1
  • Subscriptions 1

  • sleeperwolf commented,

    1. Community
    2. Ideas
    3. Ball joint Connector Completion output

    Not necessarily just the angle but how "complete" the ball joint connector is from it's initial position in terms of the X, Y, and Z axis

  • sleeperwolf created a post,

    Ball joint Connector Completion output

    1. Community
    2. Ideas

    Would it be possible to split the ball joint connector completion output into three position-specific outputs? Like a completion output dependent on how far the angle is on the X, Y, and Z axis.

    • sleeperwolf
    • 2 followers
    • 2 comments
    • 1 vote