mmdev7
- Actividad total 333
- Última actividad
- Miembro desde
- Siguiendo 0 usuarios
- Lo siguen 0 usuarios
- Votos 0
- Suscripciones 154
-
Make sure the tint in each object is reset to default (press triangle over the tint amount slider) as this can ovverride the paint on an object. This probs isn’t your issue but worth checking.You c...
-
Tap up and down on the d-pad :) Peter
-
You can’t use the mirror from the face sculpture in assembly but you can position one eye by hand then turn on and set the grid to be on the face and clone to the other side. It should line up corr...
-
If you select a user you will be taken to their profile page. Here you can push right and you will see the option to leave them a message. Hope this helps :) Peter
-
I’m not sure it is possible, sorry. What are you trying to achieve? It might be that there is another way of getting you where you need to go.But this could defo be added to feedback. :)
-
It should all be accessible in later versions but I would always save online (can still be private) just as it’s a good way to back your work up and free up hard drive space.Hope this is OK :) Peter
-
Sorry, to clarify, it shouldn’t make a difference if your work is saved online or offline. All should be safe :)
-
Plug the last output into the negetive input on a counter (set to 1, limit is 1) and wire this counter into the power input on a node. Wire any wires that are going into the selector into the node ...
-
You could wire the ‘hit something’ output from the raycast into the speed (or power) of the rotator. You could also plug this into an invertor and use that to power the forward mover.As long as the...
-
Hi, what a cool project!!! Reminds me of the little toy boat in Ponyo! :)You can simplify things by not using splitters to teach the +/- bit of the left stick. Plug the wire into the speed and set ...