Saltar al contenido principal

Búsqueda

Stop Puppet leaning after a certain angle?

LOLGuy213

Hello! I'm using motion controls to control my Deluxe Puppet's leaning, but if I move the DS4 upside-down, the puppet bends in quite an unpleasant way. Is there any way for me to hard limit the angle the Deluxe Puppet can lean? Thanks!

4 comentarios Fecha Votos
  • LadyLexUK
    Conversation starter

    Cut the wire to the lean in the puppet microchip. Problem solved. I actually do this to many of my characters as the lean does not suit. Otherwise I havent tried it but maybe you can tweak the connectors inside the puppet to limit angle of rotation?

    0
    Denunciar esta publicación
  • LOLGuy213

    I think tweaking is the way to go, as far as I know the connectors are all Ball joints. I need to use the DS4 motion controls for leaning as that plays a key role into my game mechanic.

    I know you can change Bolt joints to restrict what angles they can go to but idk if you can do the same for Ball joints?

    0
    Denunciar esta publicación
  • Denjo92

    Try putting a signal manipulator between the gyro output and the lean input. Got to the last page and look at the right side of the graph. Drag the upper line a little down and the lower a little up. This should then restrict the movement.

    Now that I think about it. You should probably split the wire and then try it with multiple manipulators

    0
    Denunciar esta publicación
  • Denjo92

    Just tried it. You don't need to split the wire.

    0
    Denunciar esta publicación

Iniciar sesión para dejar un comentario.