L1+Square to enter precise values for Signal Manipulator custom remap thresholds

TheBeardyMan 12 de enero de 2022 00:56

Originally, L1+Square to enter precise values only worked for thin wire tweaks. Then it was extended to work for fat wire tweaks. But not all fat wire tweaks - only those for which the tweak menu controls are a group of the same kind of slider controls that you get for thin wires.

And there's another fat wire for which it would be very useful - the custom remap thresholds of the Signal Manipulator gadget, which is a 4 numbers fat wire. Especially when you're using it for something like mapping one angle range in degrees to another in radians, and some of the thresholds need to be multiples of pi.

• 

  TAPgiles

  • 12 de enero de 2022 08:26

  

  Yes, exactly this! I was hoping they were slowly making their way towards it. It's *really* needed for that UI, as the numbers are often so small and it can be very finicky to get to the desired number.

  0

  Denunciar esta publicación
• 

  thyon

  • 17 de enero de 2022 20:18

  This is ridiculous to set using the up/down. You have my vote.

  1

  Denunciar esta publicación

Iniciar sesión para dejar un comentario.