Aller au contenu principal

Recherche

Choo Choo! Dreams update v2.61 - Update, Bugs & Issues Thread

Non planifiée
  • TheBeardyMan

    Snap points don't work with several guides and tools - mirror guide, kaleidoscope guide, and cut out tool in sculpt mode, and live clone tool in assembly mode. Repro steps:

    1. Start a new scene / element.
    2. Enable the snap point guide.
    3. Enable show all snap points.
    4. Enter sculpt mode.
    5. Stamp the default 0.5 x 0.5 x 0.5 cube at [0.0, 1.0, 0.0].
    6. Enable the mirror guide.
    7. Stamp a neutral snap point at [1.0, 1.0, 0.0].

    Observed: Only a single snap point at [1.0, 1.0, 0.0] is added.
    Expected: Two snap points are added, one at [1.0, 1.0, 0.0] and its mirror image at [-1.0, 1.0, 0.0].

    8. Disable the mirror guide.
    9. Enable the kaleidoscope guide.
    10. Stamp a neutral snap point at [-1.0, 1.0, 0.0].

    Observed: Only a single snap point at [-1.0, 1.0, 0.0] is added.
    Expected: Five snap points are added, one of them at [-1.0, 1.0, 0.0] and the other four completing a regular pentagon around the cube.

    11. Use the cut out tool to cut out the near bottom left corner of the cube.
    12. Exit sculpt mode.
    13. Move the cut out corner left by 3m.

    Observed: The cut out corner has no snap points.
    Expected: The cut out corner has the same snap points as the original.

    14. Make a live clone of the original sculpt at [0.0, 3.0, 0.0].
    15. Edit the original sculpt.
    16. Stamp a neutral snap point at [0.0, 1.0, 1.0].
    17. Delete the snap point at [-1.0, 1.0, 0.0].
    18. Move the snap point at [1.0, 1.0, 0.0] to [1.0, 2.0, 0.0].
    19. Exit sculpt mode.

    Observed: The live clone created in step 14 still has the set of snap points that it had when it was created.
    Expected: The snap point creation, deletion, and move in the original sculpt are propagated to its live clone.

Vous devez vous connecter pour laisser un commentaire.