Follower

Rabagast 9 janvier 2019 14:10

Is there a way to check if an object with a follower attached to it reach a destination?

• 

  mmdev1 - John & Luci

  • 9 janvier 2019 14:27

  hi,
  
  if you have a small trigger zone on the object that is following, looking for the same key the follower is trying to get to, then that will detect it when it gets there.
  
  John

  0

  Signaler cette publication
• 

  CloaknDaggerson

  • 9 janvier 2019 14:49

  One way to detect that your object has 'bumped' into your target is to put an impact sensor on it. If you want to detect when your object reaches an area put a 'Trigger Zone' gadget on it, set the zone size/shape, set it to respond to a tag labelled as 'Target' or something similar, then attach a tag with the same label (very important) to the destination or in the target area.
  
  If you want the object to report back just wire the impact sensor or trigger zone (whichever used) to a 'Wireless Transmitter', then wherever you want to receive the signal attach a wireless receiver (make sure to label both the transmitter and receiver with the same name.

  0

  Signaler cette publication
• 

  Rabagast

  • 9 janvier 2019 19:35

  Ok, thanks! ?

  0

  Signaler cette publication
• 

  Aecert

  • 9 janvier 2019 21:37

  Isnt there an output in the follower that outputs whether or not the follower has reached its destination?

  0

  Signaler cette publication

Vous devez vous connecter pour laisser un commentaire.