Trouble with rotator and camera on object.

BLAHBLAH1000shop 24 décembre 2018 19:19

I have a cube with a microchip on it. In the microchip I have a camera and a rotator. The camera is on the microchip so it follows the object. Hooked up to the rotator is a splitter and controller sensor so pushing the right stick left and right will make the rotator go left and right (X out on splitter connected to rotation speed).

Here's the problem: The rotator only rotates 180 degrees. On the edges of 180 it slows down exponentially to the point where it doesn't move at all. When I delete the camera it rotates normally. Why is the camera stopping the rotation?

Side note: another issue I'm running into is that the X output on the splitter (which should just be left and right) is also outputing up and down inputs.

Overall this is acting super weird and I don't know what's going on.

• 

  BLAHBLAH1000shop

  • 24 décembre 2018 19:43

  FIXED IT
  
  I didn't realize there are different outputs for left/right stick local. Mm if you're reading this, please have different icons for the left/right stick camera position and left/right stick local to help differentiate the two!

  0

  Signaler cette publication
• 

  Schrottmaker

  • 6 janvier 2019 22:37

  Stucked on the same problem for two weeks man :D thx for this post <3

  0

  Signaler cette publication

Vous devez vous connecter pour laisser un commentaire.