How do I make a controller input toggle?

Keaton_x 19 décembre 2018 21:18

I've tried wiring the controller input into a switch, but they only remain powered on so long as the button is held down.

Is there a simple toggle thing that I'm just missing?

• 

  Mm dev - Bogdan/Yann

  • 19 décembre 2018 23:02

  Hey, so there's a few ways of doing this, but one way I like is with a signal manipulator gadget found in logic&processing.
  
  - Wire your button (say X) into the Signal input port (left) of the manipulator.
  - Wire the Signal Output port (right) to your switch
  - Tweak the manipulator (L1+square)
  - Set remapper mode to Custom
  - At the bottom set Edge mode to Toggle Output at ON
  - Profit
  
  Hope it helps!
  
  - Yann

  0

  Signaler cette publication
• 

  Keaton_x

  • 19 décembre 2018 23:11

  Yann,
  
  You are a God. Thank you.

  0

  Signaler cette publication
• 

  Mm dev - Bogdan/Yann

  • 19 décembre 2018 23:48

  Most welcome :)

  0

  Signaler cette publication

Vous devez vous connecter pour laisser un commentaire.