allan_Huidobro

1. Community
2. Archive
3. How do I change the friction between a character and surface?

A mover/follower set to flee when touching the object could do the trick.

• Visualizza commento
• allan_Huidobro
• 22 dicembre 2018 17:13
• 0 voti

1. Community
2. Archive
3. Disable the black and white mode in sculpt mode?

It's essentially zoning everything out so that you can focus on the sculpt. If you want to edit an existing sculpt, just tunnel in to whatever you're trying to change until your sculpting tools pop...

• Visualizza commento
• allan_Huidobro
• 22 dicembre 2018 17:09
• 0 voti

1. Community
2. Archive
3. How do i make something glow on a beat

What stew suggested works, if you want specific beats, you can use a key frame, place it to record, and in the properties panel of the object, yeet the luminosity slider to the value you want. Afte...

• Visualizza commento
• allan_Huidobro
• 23 dicembre 2018 06:39
• 0 voti

1. Community
2. Archive
3. Corner editor?

The closest to the corner editor would be the stretch tool in sculpt mode. Scope in to a sculpt, and select stretch tool to stretch the primitives inside the sculpt.

• Visualizza commento
• allan_Huidobro
• 23 dicembre 2018 06:30
• 0 voti

1. Community
2. Archive
3. How do I: have an object appear in an animation without it being there from the start?

I believe there is a "Visible" button in the physics tab of the object properties. disable visible, and when recording in a keyframe, be sure to enable visibility.

• Visualizza commento
• allan_Huidobro
• 24 dicembre 2018 02:55
• 0 voti

1. Community
2. Archive
3. How do I use the L stick on an advanced mover?

I'm assuming it's moving in the opposite direction of what is wanted? If so I would grab a signal manipulator, select custom modulation(I forget the word, might be waveform), and then under the ty...

• Visualizza commento
• allan_Huidobro
• 24 dicembre 2018 04:03
• 0 voti

1. Community
2. Archive
3. How to make my puppet stand

I think you have to keyframe it. I haven't tried it myself though.

• Visualizza commento
• allan_Huidobro
• 25 dicembre 2018 01:41
• 0 voti

1. Community
2. Archive
3. Thermometer

Have you used the "Sculpture Detail" tool in the tools section? It has helped me cut the thermometer in half for a lot of my creations. And user Fahran stated they cut their sub from 93% down to 7%...

• Visualizza commento
• allan_Huidobro
• 27 dicembre 2018 03:30
• 0 voti

1. Community
2. Archive
3. Why can you see Unpublished stuff in “Browse All”?

You can see the things in your ps4 in the general search, won't pop up for others

• Visualizza commento
• allan_Huidobro
• 27 dicembre 2018 03:20
• 0 voti

1. Community
2. Archive
3. How do I make an object fade in and out of existence?

Following up on what sdcxsfd said, you can probably paint over the object you want using surface snap, increase opacity of the paint strokes, and then enable "Viewable" for the object.

• Visualizza commento
• allan_Huidobro
• 14 gennaio 2019 23:47
• 0 voti