Advanced rotator sensitivity
Iv built a FPV racing drone. I have the thrust linked to a mover shooting my object up.
And i have linked my yaw roll and pitch to advanced rotator using the sticks.
I have the speed of the Y,R,P set just right so one flick of the stick will give me a 180' spin on that axis.
Except now it is to sensative at the begining of the stick input.
My question is how can i change the sensitivity of the stick controls so i have a more
linear curve or slower roation at beging and middle of stick but a lot fast at the end. Hope this make sense to somebody
Thanks for your time
-
Hi, if you pass the wire into a calculator before you put it in the rotator you can set the calculator to "Power Of" which will give you a power curve. Set the second slider on the calculator to 2 to raise the input to the power of 2 (square it) or higher if needed. The higher the number the more small values will be reduced, however a value of 1 will still map to 1.
Hope that helps
Matt
댓글을 남기려면 로그인하세요.