How do I use the L stick on an advanced mover?
I'm trying to make a movable object using the L stick of the controller sensor in X and Y axis and when I connected it to the splitter and then onto the advanced mover on the X and Y pluggings it moves in wrong directions, i've even swap the wires and still doesn't move properly.
Help please
-
I'm assuming it's moving in the opposite direction of what is wanted? If so I would grab a signal manipulator, select custom modulation(I forget the word, might be waveform), and then under the types of manipulation, there should be a graph. Drag the bottom bar of the first half down to -1, and on the right side, move the bottom bar up to 1, and the bar on top to -1. What this should do is flip values to the opposite value. Duplicate. Plug in your x and y inputs to each Signal Manipulator. Plug in outputs to mover.
-
You have to connect to X & Z oddly enough. See some of my posts with replies incl. from Mm. Hope this helps.
댓글을 남기려면 로그인하세요.