Variable not updating when detected in Zone
I have a micro chip on a Emitted Object. When that object gets detected by a trigger zone I wanted to increase the variable modifier by 1 to show the number of objects destroyed.
I have no idea what I'm doing wrong. I made sure the variable is named correctly. I also split the wire from the detected out put port on the trigger zone to see if maybe the think wire had a specific wire to use. Nope.. Any suggestions?
-
Change the input from the trigger zone value to the power ?
-
Sorry that last reply wasn't very clear - Instead of the input from the detection zone going into the operation value of the VMod, have it going to the power input of the VMod.
This will then 'add 1' when 'powered on' detected. -
First off thank you Nemma for replying back to me.
I understood on your first response on what you were suggesting.
I swore I tried what you are suggesting but I will try it again this evening to make sure.
I have a feeling this is a bug though as I am using the current input port for another situation with a timer and that is working fine bug let me give it a whirl.
Tks again :) -
That worked.. I swore I tried that but I'm happy I circled back around to try "again".
Thank you for the advice!!
댓글을 남기려면 로그인하세요.