Change the radius of rounded cube.
When stamping a rounded cube you can see the white outlines where the rounded edges blend into the flat surface. I would like to move these lines, but keep the cube the same size. How do I do that?
In the end imagine I have two cubes of the exact same size but one has very large curves and is hardly looking like a cube while the other has very small curves.
-
Hey,
There's currently no control over the edge radius of the rounded cube shape, sorry!
- Liam -
Hi, its Christophe from Mm.
Like Liam said, there is no control, despite that, im using a rounded cube,
then i place few of them next to each other, overlapping each other to fit the size of the cube i want.
its the only way to do this so far. -
Thanks, and here I was certain I had actually used that feature already...
-
I'd love this as well! Would make rigid modelling a lot easier. :)
댓글을 남기려면 로그인하세요.