Arcas-X
- 총 활동 수 11
- 마지막 활동
- 회원 가입일
- 내가 팔로우하는 사용자 수 0명
- 나를 팔로우하는 사용자 수 0명
- 투표 수 0
- 구독 수 4
-
Arcas-X님이 에 댓글을 입력함
Try going into play mode and returning into create. That worked when one of my stamps was essentially invisible.
-
Arcas-X님이 에 댓글을 입력함
Not too sure you can just emit a tag. Can you attach it to a blank invisible square with the tag and just emit that?
-
Arcas-X님이 에 댓글을 입력함
Sounds like the follower minimum distance is too low. Set it to 1 or something similar. Alternatively you can make the follower non collidable.
-
Arcas-X님이 에 게시물을 만듦
How to use key frames plus a mover on a creature?
I have a four-legged creature that uses key frames to move it's legs but I'm trying to get it to move forward too. I tried adding forward movements with each key frame but it always reset to the fi...
-
Arcas-X님이 에 댓글을 입력함
This worked perfectly. You are a genius! Thank you.
-
Arcas-X님이 에 게시물을 만듦
How do I stop a controlled object inching up as it hits things?
I have a machine that hovers and moves around great, only problem is its vertical alignment getting knocked off if it hits anything too hard. It will go up and not come back down. Is there anyway I...
-
Arcas-X님이 에 게시물을 만듦
How do I stop something from using the advanced mover?
I have an advanced mover attached to a sculpt. How can I let it move for a few seconds and then just stop? Besides using the move recorders? I feel like there's some obvious logic i'm missing but I...