Multiplayer variable setting.

Zupaton 8/10/2019 08:30

I see it’s been asked a few times already but not completely answered.
Does anyone know how or even if this feature works?
In a nutshell how you feed a multiplayer variable set.

Although I feed a variable (set gadget) set to multiplayer with fat wires or specifically splitted player signals, it doesn't seem that I can get different values for each player displayed. :/

• 

  AndymationB

  • 8/10/2019 11:49

  https://feedback.indreams.me/forums/917431-dreams-bugs/suggestions/38542897-persistent-variables-don-t-save-multiplayer-values
  
  The Mm response in the above linked thread outlines it a bit. However, I haven't yet had the opportunity to play with it myself, so that's the extent of my usefulness on the subject. :P

  0

  Zgłoś ten wpis
• 

  Zupaton

  • 8/10/2019 19:49

  Either your usefulness was far extended or my blindness reduced today. lol
  I managed to get there finally and was as Matt in the thread you mentioned explaines it.
  You feed the SET VARIABLE gadget with a fat signal that contains player info and when you want to display it you feed a SPLITTER with a fat wire coming from a GET VARIABLE gadget.
  At the SPLITTER end you get different values from the output of the ports numbered 1,2,3 and 4 that correspond to the player number.
  
  Silly me, I couldn’t figure out that splitting a fat cable containing player information and feed the different number to variables works only as a trigger and not player correspondence number. 8D
  
  Thanks for the response. :)

  0

  Zgłoś ten wpis
• 

  TAPgiles

  • 9/10/2019 07:26

  In case it helps others figure it out, it works similarly to how the score gadgets work. https://www.youtube.com/watch?v=DMgk4mOMoTo&t=322s

  0

  Zgłoś ten wpis
• 

  Zupaton

  • 9/10/2019 10:16

  Yep. Totally helps. :) Especially like me who can’t get around a single player variable either. :D

  0

  Zgłoś ten wpis

Zaloguj się, aby dodać komentarz.