Nemma88
- Atividade total 31
- Última atividade
- Membro desde
- Seguindo 0 usuário
- Seguido por 0 usuário
- Votos 0
- Assinaturas 14
-
If you enable the view for connectors you should be able to find that connector joint and view / change any limitations in its tweak menu, ball joints can be set up with limited movement. If you co...
-
Maybe it's a curve shape with one end tapered rather than a cylinder?
-
Change the input from the trigger zone value to the power ?
-
Sorry that last reply wasn't very clear - Instead of the input from the detection zone going into the operation value of the VMod, have it going to the power input of the VMod. This will then 'add ...
-
First time I tried to implement this I couldn't get the results and then got distracted by the community Jam. Coming back into it, I've now got this to work as the instructions, so a late thanks!
-
Bit late but this happened to me when one element was not able to be published as it had part of a MM prize item saved with it. As I tried publishing the dream and elements at the same time this wa...
-
I havn't found any physics properties that do this well on their own. I've used combinations of connectors on a puppet previously to allow some movement. so for example it could cut in half and con...
-
The timelines have a 'On end' (or words to that effect 'Finished'?) output you can use to start a short timer to pulse the randomizer. Each timelines on end should be input into the timer. When a t...
-
When you have a timeline open, if you hover over the canvas there is a shortcut for zooming in. I believe this is L1 + Directional buttons left and right for DS4.
-
If you want some more ways, have the toggle as a selector. Two outputs. Triangle sets to next output. Have the logic for drawing the gun powered from output B. Put the fire logic in a microchip, an...