Slow power keyframe in timeline but keep changes on finished?

Scitendo 27/07/2020 12:52

What is the best way to slow power a key frame in a timeline but when the timeline ends it remains powered? And then also later be able to easily reset it to start the whole thing over again. Currently I use a not gate toward the end of the timeline as the key frame in the timeline becomes fully powered. That not gate toggles the key frame at full power outside the timeline. And the it can be reset. I know there is keep changes option but to reset it not sure which better.

• 

  TAPgiles

  • 27/07/2020 13:50

  Use another keyframe before it, setting the start position, with keep changes also. Then use L1 + X between them to have them blend.

  0

  Пожаловаться на эту публикацию
• 

  Scitendo

  • 27/07/2020 18:30

  What I currently have is a timeline with a keyframe being slowly powered. Then I have a copy of the keyframe outside the timeline. There is a not gate at the end of the timeline that toggles a counter to keep the keyframe outside of the timeline powered after it finishes. This way I can then reset the whole thing to do the entire sequence again. Currently not using the keep changes option for any keyframes. Are you saying to replace this configuration with two blended keyframes in the timeline, both with keep changes? How to reset it then?

  0

  Пожаловаться на эту публикацию
• 

  TAPgiles

  • 29/07/2020 10:31

  Well no, that sounds like it should work. Is it not working? I'm really confused now.

  0

  Пожаловаться на эту публикацию
• 

  Scitendo

  • 30/07/2020 11:23

  Thanks, what I currently have works fine but was wondering if there is a better way.

  0

  Пожаловаться на эту публикацию

Войдите в службу, чтобы оставить комментарий.