Graphic ADSR

PassTheRizla 17/07/2019 10:10

Any advice on creating a Graphic ADSR Envelope as seen in a sound gadget, so it would work the same way using grab points.

I have tried a few physical ways like trapping puck shapes inside a cutout or sliders etc, the sculpt wants to rotate or just pops out despite being constrained & dampened.

I'm thinking that i should use movers to move my points instead of the imp grab,that would stop the rotation in the z axis, I'd like advice on the mechanism as thats where im falling down each attempt.

• 

  Mm Bogdan & Matt

  • 17/07/2019 14:40

  Hi,
  I think I would try making an invisible block and sticking a controller sensor on it with "follow imp" set. Then put a key on the invisible block and get your points to follow the key when being "grabbed". If you use a follower to do the following you can constrain to particular axes if necessary. You shouldn't get any rotation if you disable collisions for the point. Using a teleporter will give you less lag but is a bit less flexible.
  Hope that helps
  Matt

  0

  Пожаловаться на эту публикацию
• 

  PassTheRizla

  • 17/07/2019 22:35

  Thanks, was not aware of follow imp on controller sensor, that will be useful for so much!

  0

  Пожаловаться на эту публикацию

Войдите в службу, чтобы оставить комментарий.