double text after using logic

Marcel_Arts 12/05/2019 10:50

Hey, I could use some help with a weird glitch, I'm having.
I wanted a character to say two different things, based on whether an event has happened. My logic is as follows:
Variable: "Event" -> When the event happened, I put +1 on an variable modifier set on "Event".
In the character:
If "Event" = 0 -> Sentence 1
If "Event" = 1 -> Sentence 2
I used the calculator with that.
The logic works, that is not the problem. The problem is, that if "Event" = 0, Sentence 1 appears twice. So after I close the sentence, it appears again and when I close that two it stays that way. That didn't happen before, when their was only one possible sentence and it also doesn't happen with sentence 2. I can't figure out, why that is. Does anybody have an idea?

• 

  Agarwel

  • 12/05/2019 13:16

  My guess is that first condition "=0" is true even before you start testing - because you are not sending any input inside so it is considered 0 and text appears even before you want it to.
  I would probably start counting from 1 for this reason or you will have to make sure that no signal is handled differently than 0 signal.

  0

  Пожаловаться на эту публикацию
• 

  Marcel_Arts

  • 13/05/2019 19:31

  Cool idea. Didn't work unfortunately. Same problem. I include a pic of the logic. Dunno if that helps...

  0

  Пожаловаться на эту публикацию
• 

  Supposer

  • 18/05/2019 21:49

  A bit hard to say without getting in there and fiddling with things. If you like, you can send me a remixable creation, or temporarily add me as a collaborator to it so I can take a closer look.

  0

  Пожаловаться на эту публикацию

Войдите в службу, чтобы оставить комментарий.