Stop Puppet leaning after a certain angle?

LOLGuy213 27/04/2019 17:04

Hello! I'm using motion controls to control my Deluxe Puppet's leaning, but if I move the DS4 upside-down, the puppet bends in quite an unpleasant way. Is there any way for me to hard limit the angle the Deluxe Puppet can lean? Thanks!

• 

  LadyLexUK

  • 27/04/2019 23:56

  

  Cut the wire to the lean in the puppet microchip. Problem solved. I actually do this to many of my characters as the lean does not suit. Otherwise I havent tried it but maybe you can tweak the connectors inside the puppet to limit angle of rotation?

  0

  Пожаловаться на эту публикацию
• 

  LOLGuy213

  • 28/04/2019 09:44

  I think tweaking is the way to go, as far as I know the connectors are all Ball joints. I need to use the DS4 motion controls for leaning as that plays a key role into my game mechanic.
  
  I know you can change Bolt joints to restrict what angles they can go to but idk if you can do the same for Ball joints?

  0

  Пожаловаться на эту публикацию
• 

  Denjo92

  • 29/04/2019 09:15

  Try putting a signal manipulator between the gyro output and the lean input. Got to the last page and look at the right side of the graph. Drag the upper line a little down and the lower a little up. This should then restrict the movement.
  
  Now that I think about it. You should probably split the wire and then try it with multiple manipulators

  0

  Пожаловаться на эту публикацию
• 

  Denjo92

  • 29/04/2019 10:03

  Just tried it. You don't need to split the wire.

  0

  Пожаловаться на эту публикацию

Войдите в службу, чтобы оставить комментарий.