How Do I : Make puppet press a button, for lets say to turn on the lights

OrionSk8 21/04/2019 19:18

I made a switch and timeline, wired "square" to the switch and timeline but I want it to work only if I am near enough to press it, I can litteraly press it and light will turn on if I am not near it, I want it only to work when I am close enough

• 

  Supposer

  • 22/04/2019 04:24

  Add a trigger zone to the area you want to activate this functionality from. Use an AND gate with the zone and square button plugged into it, and wire that into the light.

  0

  Пожаловаться на эту публикацию
• 

  OrionSk8

  • 22/04/2019 17:21

  I dont know what am i doing wrong, do I still need the switch? also does it matter if its input A or B..results go to the light??

  0

  Пожаловаться на эту публикацию
• 

  Mm Bogdan & Matt

  • 26/04/2019 09:30

  You don't really need the switch. Replace it with the AND gate as Supposer mentions. It doesn't matter which input (A or B) you plug into as long as the trigger zone is plugged into one and the square button is plugged into the other. The light will then only come on when the trigger zone detects somethings AND you've pressed square.
  thanks
  Matt

  0

  Пожаловаться на эту публикацию
• 

  Exinferis9007

  • 06/08/2019 20:05

  How do you get the light to turn off with the same button press?
  
  I've got the light hooked up to a controller sensor and gate and trigger zone. The light turns on and stays on but I can't figure out how to then turn it off with the same button press.

  0

  Пожаловаться на эту публикацию

Войдите в службу, чтобы оставить комментарий.