When Combining 3 wires into a Fat wire, how can I control which is which?

GBO-Possum 25/01/2019 20:54

I’m calculating X, Y and Z coordinates for input into a Follower via “Target Position” to control the location of an object.

The Calculators are each wired into ports A, B and C of a Combiner, and the Fat Wire output is connected to Target Position on the Follower.

It appears that in my experiment, “B” is controlling the vertical (Y) position. Can I assume that A, B, C always map to X, Y and Z in that sequence?

Note that I’m not sure how to distinguish the X and Z axes, so explaining that would be a help too.

Thank you!

• 

  Paronome

  • 26/01/2019 16:52

  Hello !
  I dindn't try to move objects but i used combiners.
  
  If you link something to the first channel of the combiner, it will be linked to the first channel of the splitter. If i assign X to the first channel of the combiner i can find X in the fisrt channel of my splitter ;)

  0

  Пожаловаться на эту публикацию
• 

  GBO-Possum

  • 27/01/2019 19:27

  It may be that the "Target Position of a Follower" behaves like the "input ports of a Combiner" in that the positions always map to the XYZ parameters in that sequence.
  
  Or maybe not!
  
  I ma SO looking forward to some actual documentation!!

  0

  Пожаловаться на эту публикацию

Войдите в службу, чтобы оставить комментарий.