Controller Sensor

Rabagast 05/01/2019 08:55

When I press "X" on the controller, it sends a signal to an object to make it glow, but when I release the button, the signal turns off, so the glowing is set back to 0. How can I make the signal I send to stay on?
The same happen when I enter and exit a trigger. The signal turns on and off.

• 

  mmdev7

  • 05/01/2019 09:26

  Wire x into a counter with max value 1. Then wire the counter into glow. This will set the glow on perminantly.
  
  If you want glow to be toggled on/off with each press of x wire it into a selector.
  
  Hope this helps :) Peter

  0

  Пожаловаться на эту публикацию
• 

  Rabagast

  • 05/01/2019 14:38

  Thank you. I will try it later today. :)

  0

  Пожаловаться на эту публикацию

Войдите в службу, чтобы оставить комментарий.