Blocking signals in a custom selector

Scitendo 28/02/2020 14:56

I have slightly modified the behavior of the selector by putting one on a microchip and connecting ports A-J to counters. This was to allow the signals to persist as the selector loops through A-J. My microchip has equivalent A-J input nodes and an equivalent input active port node. The latter connects to the same on the selector. The former go to A-J output nodes depending on the corresponding counters. The microchip functions like a pass through selector but where the signals persist. Now here is my issue. Once a signal is started by way of the counter I not only want it to persist but also prevent the original data on the signal from being changed once the next signal begins. And so forth. Please help because I can’t seem to find a way to do this.

• 

  TAPgiles

  • 29/02/2020 22:38

  Okay... to be honest I have no idea what this is about. BUT! I'll try to help ;P
  
  If you want to freeze a value, you can put it through a signal manipulator and then turn on "freeze" when you want to freeze it. It'll keep outputting the same value until you turn off "freeze."
  
  That help?

  0

  Пожаловаться на эту публикацию
• 

  TAPgiles

  • 29/02/2020 22:39

  (Duplicate post)

  0

  Пожаловаться на эту публикацию

Войдите в службу, чтобы оставить комментарий.