How to use a select gadget

Alfinch 28/01/2019 19:29

Perhaps there's an easy answer to this, but it has me stumped.

I have a signal generator which is putting out a fast blinking signal, and a second signal which counts 0, 1, 2 in a cycle. I want the first signal to travel down one of three wires depending on the value of the second. I thought a select gadget would be ideal for this with the acive port input controlling which port carried the signal, but I get incredibly weird behaviour - see the video.

What's actually going on here, first of all? Also, how can I get the blinking signal to only output from each port in turn?

• 

  Aecert

  • 28/01/2019 20:04

  Try selecting the passthrough option in the selector.

  0

  Пожаловаться на эту публикацию
• 

  Alfinch

  • 28/01/2019 21:10

  That's what I did - I'm trying to pass the values through the selector.

  0

  Пожаловаться на эту публикацию
• 

  Aecert

  • 28/01/2019 21:14

  Ok this is what you need to do. Pass the signal to each of the 3 cubes using nodes. Wire a b and c of the selector into each of the 3 nodes. Turn off passthrough. This should work.

  0

  Пожаловаться на эту публикацию
• 

  Aecert

  • 28/01/2019 21:14

  into the power of the 3 nodes **

  0

  Пожаловаться на эту публикацию
• 

  Alfinch

  • 28/01/2019 21:51

  Just tried this and it works! Fantastic, thanks :)

  0

  Пожаловаться на эту публикацию

Войдите в службу, чтобы оставить комментарий.