Set an emitter to a specific angle

KlawUK 12/01/2019 15:01

Eg how do I get an emitter to emit an object 30 degrees from vertical? I want to feed a specific value in to ensure consistency rather than adjusting the arrow by eye as I want several emitters all working together

If I put a value slider into the ‘scene space direction’ the object flies off at great speed even though it is set to the same 3m/s as the otherwise identical emitter next to it which is much slower.

Tried combining the output of a value slider into a 3 value fat wire, and then that into the rotation input of a combined set to ‘transform’, but no joy

How do angles even work in dreams - what range do they use?

• 

  KlawUK

  • 12/01/2019 15:34

  Ok so playing with this is making me very confused. I have three value sliders going into a combiner with the output being a rotation fat wire. The output goes into the scene space direction in an emitter.
  
  If I tweak the emitter so I can see the angle, and then adjust the sliders I do not understand the result.
  
  Eg adjusting the value going in to The Y input of the combiner, 0 points horizontally left. Increasing up to about +45 the angle goes up roughly in line with degrees. But then starts to move less as I increase the value. Even at 256 I can’t get it to point directly up.

  0

  Пожаловаться на эту публикацию
• 

  MrKlawUK

  • 12/01/2019 16:28

  This is the kind of thing I want to do - but basically control the angle
  
  https://i.postimg.cc/C5nSX4Qp/0-A20-FDDC-73-C7-48-DA-93-C4-BB3-B8047-C3-DE.jpg

  0

  Пожаловаться на эту публикацию
• 

  Taylor

  • 03/04/2020 11:29

  What are the rotation input values

  0

  Пожаловаться на эту публикацию

Войдите в службу, чтобы оставить комментарий.