eliminate bobblehead effect on puppet

DrunkenFist_Lee 03/01/2019 00:48

I made a puppet with a large head but no matter how I tweak my settings, I can't get gameplay animation I'm satisfied with. I turned off auto-look and all gyroscope control. Tweaked stiffness way up and even tried tweaking the joint settings themselves. Also tried giving the head zero weight.

Head is certainly better than it was, but still looks super funky while jumping. Mostly at the point of lift-off and landing. Head and/or upper torso flop about in ways that drive me batty. Any tricks I'm missing?

• 

  DrunkenFist_Lee

  • 03/01/2019 00:49

  Briefly tried a gyroscope, too. That went super-wrong, lol.

  0

  Пожаловаться на эту публикацию
• 

  Nurbldoff

  • 03/01/2019 05:38

  Hard to say, but if it's mostly when jumping, maybe you just need to modify those keyframes?

  0

  Пожаловаться на эту публикацию
• 

  madduey

  • 05/01/2019 10:50

  Set your puppet to ignore motion controls. Turn it off in the controller sensor

  0

  Пожаловаться на эту публикацию

Войдите в службу, чтобы оставить комментарий.