Change the radius of rounded cube.

ruolbu 25/12/2018 13:24

When stamping a rounded cube you can see the white outlines where the rounded edges blend into the flat surface. I would like to move these lines, but keep the cube the same size. How do I do that?

In the end imagine I have two cubes of the exact same size but one has very large curves and is hardly looking like a cube while the other has very small curves.

• 

  mmdev5 - Liam

  • 25/12/2018 13:50

  Hey,
  
  There's currently no control over the edge radius of the rounded cube shape, sorry!
  
  - Liam

  0

  Пожаловаться на эту публикацию
• 

  urbandevill

  • 26/12/2018 20:56

  Hi, its Christophe from Mm.
  Like Liam said, there is no control, despite that, im using a rounded cube,
  then i place few of them next to each other, overlapping each other to fit the size of the cube i want.
  its the only way to do this so far.

  0

  Пожаловаться на эту публикацию
• 

  ruolbu

  • 27/12/2018 01:25

  Thanks, and here I was certain I had actually used that feature already...

  0

  Пожаловаться на эту публикацию
• 

  mawltea

  • 24/04/2019 17:54

  I'd love this as well! Would make rigid modelling a lot easier. :)

  0

  Пожаловаться на эту публикацию

Войдите в службу, чтобы оставить комментарий.