Option not to move other end of wire in hand to next tweak in expanding array when using "attach and clone wire"

TheBeardyMan 12/01/2022 09:46

At present, after you use "attach and clone wire" with a wire in hand whose other end is connected to a tweak in an expanding array, the other end of the new wire in hand will always be connected to the next tweak in the array.

But that's not always what you want - sometimes you want the other end of the new wire in hand to be connected to the same tweak in the array. And if it's the first time you've used "attach and clone wire" with a wire from and expanding array, but not the first time you've used it in general, the other end moving to the next tweak can be a surprise. Especially when the place where you're making the connections is so far from the other end that you can't see it - you could end up with many wires connected to different tweaks when you expected them to be connected to the same tweak.

Conveniently, "attach and clone wire" already has two button combinations assigned to it - L1+Cross and L1+R2. The behaviour of one these could be changed to leave the new wire in hand connected to the same tweak of an expanding array, while the other could retain the original behaviour.

• 

  TAPgiles

  • 12/01/2022 09:58

  

  Ah yeah that could be a good alt control for it. Though I use those interchangeably now so it would take me some time to get used to again XD

  0

  Пожаловаться на эту публикацию

Войдите в службу, чтобы оставить комментарий.