Multiple Point Slider/Piston Connector

Orue223 17/12/2022 19:35

Currently its difficult to make a slider for example that follows a L shape because it stops at either end of a straight line. What if there was a new connector type that had multiple points that let the object slide from one point to the next point?

• 

  TheGoldNinja10

  • 18/12/2022 00:45

  you can approximate this using keyframes on a timeline. set each keyframe to each "node" position you want, turn off smoothing on each keyframe, apply a linear transition between each one, and plug in your signal to the Playhead Position.

  0

  Пожаловаться на эту публикацию
• 

  TAPgiles

  • 18/12/2022 12:31

  

  Or even just use one piston to move the first bit, and another piston to move in the other direction. Activate them one at a time.

  0

  Пожаловаться на эту публикацию
• 

  Orue223

  • 19/12/2022 03:38
  • Изменен

  I've used both these solutions theyre good for certain things but are bad overall. Like say if I created an L shape and rotated it with physics on, the moving part of the connector wouldnt be correct. The L shape is just an example what if I wanted to create an elaborate shape? basically just not worth the setup. Multiple points would open up new logic possibilites and game ideas.

  0

  Пожаловаться на эту публикацию
• 

  TAPgiles

  • 19/12/2022 08:44

  

  Right. So using sliders instead and keyframing would sort that. Or just keyframing with no connectors. How did those methods work out for you?

  0

  Пожаловаться на эту публикацию
• 

  Orue223

  • 19/12/2022 16:54

  It wouldnt react physically correct though. Say I attach a follower to the moving part of it. Its gonna stop at the end of a connector. What if I want to change the shape? Have to redo the whole thing

  0

  Пожаловаться на эту публикацию
• 

  Denjo92

  • 12/01/2023 03:02

  So basically a "Spline" tool?

  Yes please!

  1

  Пожаловаться на эту публикацию

Войдите в службу, чтобы оставить комментарий.