Nemma88

1. Сообщество
2. Archive
3. Logic to increase numeric value (from min to max) over a set period of time

First time I tried to implement this I couldn't get the results and then got distracted by the community Jam. Coming back into it, I've now got this to work as the instructions, so a late thanks!

• Посмотреть комментарий
• Nemma88
• 07/06/2019 15:20
• 0 голосов

1. Сообщество
2. Archive
3. How do I make the following logic? Pls help

If you want some more ways, have the toggle as a selector. Two outputs. Triangle sets to next output. Have the logic for drawing the gun powered from output B. Put the fire logic in a microchip, an...

• Посмотреть комментарий
• Nemma88
• 30/05/2019 06:01
• 0 голосов

1. Сообщество
2. Archive
3. How do I change the time increments on the timeline?

When you have a timeline open, if you hover over the canvas there is a shortcut for zooming in. I believe this is L1 + Directional buttons left and right for DS4.

• Посмотреть комментарий
• Nemma88
• 29/05/2019 07:29
• 0 голосов

1. Сообщество
2. Archive
3. How do I make something bendy?

I havn't found any physics properties that do this well on their own. I've used combinations of connectors on a puppet previously to allow some movement. so for example it could cut in half and con...

• Посмотреть комментарий
• Nemma88
• 28/05/2019 07:27
• 0 голосов

1. Сообщество
2. Archive
3. Timers, randomisers and timelines

The timelines have a 'On end' (or words to that effect 'Finished'?) output you can use to start a short timer to pulse the randomizer. Each timelines on end should be input into the timer. When a t...

• Посмотреть комментарий
• Nemma88
• 28/05/2019 07:21
• 0 голосов

1. Сообщество
2. Archive
3. Error publishing Dream

Bit late but this happened to me when one element was not able to be published as it had part of a MM prize item saved with it. As I tried publishing the dream and elements at the same time this wa...

• Посмотреть комментарий
• Nemma88
• 23/05/2019 09:36
• 0 голосов

1. Сообщество
2. Archive
3. Custom animation issues.

If you enable the view for connectors you should be able to find that connector joint and view / change any limitations in its tweak menu, ball joints can be set up with limited movement. If you co...

• Посмотреть комментарий
• Nemma88
• 13/05/2019 08:50
• 0 голосов

1. Сообщество
2. Archive
3. How did they make the tapered cylinder in the stock puppet's head?

Maybe it's a curve shape with one end tapered rather than a cylinder?

• Посмотреть комментарий
• Nemma88
• 13/05/2019 08:44
• 0 голосов

1. Сообщество
2. Archive
3. Variable not updating when detected in Zone

Sorry that last reply wasn't very clear - Instead of the input from the detection zone going into the operation value of the VMod, have it going to the power input of the VMod. This will then 'add ...

• Посмотреть комментарий
• Nemma88
• 13/05/2019 07:10
• 0 голосов