How do I freeze a signal from X that is also unfrozen with X?

jgr9 2019年01月11日 00:12

I guess my first question is actually, wasn't there a tutorial that froze a signal with the signal manipulator? Which tutorial was that and what step?

This is probably simple logic stuff here, but...

I need holding X to stop something from happening (Not Gates aren't an issue for me). But I need that signal to freeze until X is pressed again, not unfreeze when it's released.

I'm just trapped on what I need to do here. I think finding that Signal Manipulator freeze tutorial would help me out, unless that's not the way to do it.

• 

  olit123

  • 2019年01月11日 01:49

  Use a selector. Make output A off and output B on. Start with A selected then wire up the x button to move to next output, once pressed the selector will switch to B which is your on state and then when it is pressed again it will go back to the beginning (A); your off state.
  Hope that helps.

  0

  回報此貼文
• 

  jgr9

  • 2019年01月11日 02:16

  Yup, I actually aleady did that, thanks.

  0

  回報此貼文
• 

  Aecert

  • 2019年01月11日 20:43

  a signal manipulator also works, and it takes up less space in the micro chip. Just set it to custom remapping, then to toggle on input on. Will do exactly the same thing.

  0

  回報此貼文

請登入寫評論。