Can I attach a microchip node output to an object rather than a property?

presssquaretoeat 2019年05月12日 19:26

I have a logic chip with several rotators that affect the same object under different conditions; If I wire the Affected Object(s) output of the rotators to an output node I cannot link that output wire to the object I want rotated.

I'd like to stamp my chip and connect one wire to the object I want affected, is this possible?

• 

  Mm Bogdan & Matt

  • 2019年05月13日 13:45

  Hi,
  if all the rotators affect the same object you shouldn't need to use the Affected Object output directly. Just stick the logic chip onto object and all the rotators will affect the object that the chip is stuck on. You can then clone that chip and stick it on another object and all the rotators will now affect the new object.
  If you don't want to stick the chip directly on the object then you can instead wire the microchip using it's "Apply To Object" input to the new object and all the rotators on it will now affect the new object.
  We don't currently support wiring those types of outputs through nodes.
  thanks
  Matt

  0

  回報此貼文
• 

  presssquaretoeat

  • 2019年05月13日 21:03

  Thanks Matt! Totally obvious answer in hindsight but I completely missed it. Cheers :-)

  0

  回報此貼文

請登入寫評論。