Entropy-Tamed
- Total activity 14
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 6
-
Entropy-Tamed commented,
You could probably set up multiple controller gadgets with different setups depending on what you were animating. You could then power on the one with the control scheme you want at the time and po...
-
Entropy-Tamed commented,
Use this tool perhaps...https://indreams.me/guide/palette-glossary/model/shapes/curveOr soft blend off the top of a cone.
-
Entropy-Tamed commented,
You’ll need to grab the sculpt and tunnel in to the puppet while holding the button to move your sculpt.
-
Entropy-Tamed commented,
Just in case anyone else reads this with the same problem I think it was a ‘finish’ covering my shape that was obscuring the color applied to the sculpt.
-
Entropy-Tamed commented,
Are you sure it was in a “dream” and not something else?
-
Entropy-Tamed commented,
I was feeling that pain as well.
-
Entropy-Tamed commented,
It’s odd. It worked in a new sculpt but when editing one particular sculpt I couldn’t get it to work. Even in stamp mode.
-
Entropy-Tamed created a post,
Subtracting from sculpt with colored primitive... Is that supposed to leave a colored negative space? I thought I'd seen this done.
I'm probably just missing something obvious but I can't figure it out. I hit L1+X to tunnel into a sculpt and then try to subtract with a differently colored shape and it remains the same color des...