Can you wire up a gadget inbetween another gadget and its output wires.

sdcxsfd 12/01/2019 20:21

Hi all, not really sure if the title makes any sense, but I have a signal generator on a microchip, and its output is connected to the opacity of lots of different things. If I want to then put more gadgets inbetween the signal generator and all the wires that are going off of the microchip and into the opacity sliders, say a calculator, how do I do this? I can wire the sig gen into a calculator, but then I cant connect the calculator to the node that all of the wires come off. I know i could do it manually, but it would take so long as everythings an indivudial painting and id have to scope in to each and everyone and wire them up. Thanks :)

• 

  mmdev1 - John & Luci

  • 12/01/2019 21:11

  Hi,
  
  You can pick up either end of existing wires,
  So add you new gadget and attach to the generator, then just grab all the other wires going into the generator and put them into the new gadget.
  
  John

  0

  Пожаловаться на эту публикацию
• 

  sdcxsfd

  • 12/01/2019 21:37

  Ahh, thank you, i was trying to pull a wire out from the node at the edge of the microchip and do it that way, totally slipped my mind to grab the wires :p

  0

  Пожаловаться на эту публикацию

Войдите в службу, чтобы оставить комментарий.