Arcas-X
- 活動總數 11
- 最後一個活動
- 成員加入日期為
- 追蹤 0 個使用者
- 跟隨者 0 個使用者
- 投票數 0
- 訂閱數 4
-
Arcas-X 已評論，
Try going into play mode and returning into create. That worked when one of my stamps was essentially invisible.
-
Arcas-X 已評論，
Not too sure you can just emit a tag. Can you attach it to a blank invisible square with the tag and just emit that?
-
Arcas-X 已評論，
Sounds like the follower minimum distance is too low. Set it to 1 or something similar. Alternatively you can make the follower non collidable.
-
Arcas-X 已建立貼文，
How to use key frames plus a mover on a creature?
I have a four-legged creature that uses key frames to move it's legs but I'm trying to get it to move forward too. I tried adding forward movements with each key frame but it always reset to the fi...
-
Arcas-X 已評論，
This worked perfectly. You are a genius! Thank you.
-
Arcas-X 已建立貼文，
How do I stop a controlled object inching up as it hits things?
I have a machine that hovers and moves around great, only problem is its vertical alignment getting knocked off if it hits anything too hard. It will go up and not come back down. Is there anyway I...
-
Arcas-X 已建立貼文，
How do I stop something from using the advanced mover?
I have an advanced mover attached to a sculpt. How can I let it move for a few seconds and then just stop? Besides using the move recorders? I feel like there's some obvious logic i'm missing but I...